4-13-06 Here is the COIL OVERS that were originally for a 240z, and then I lengthened the 240z strut tubes, and setup to use this on a 280z.  I am using ArizonaZCars Coil overs and Control arms.  Adjustable camber plate pics installed also, no external welds!

Here is a shot of the mono ball, and special thrust nut for use with the mono ball.

ToKico Illumina's are used with this setup.

Here is a shot of the Special Spacer, which is made of 17-4PH stainless, and is clearenced for the mono ball setup.

Here is a shot of the coil over spring, sleeve, and nut, and the screw that holds the sleeve to the strut tube

Shot of the Rear strut tube, and sectioned piece,  1.562" lengthened, and 17-4 Ph stainless was used again, and 3-12-16 stainless welding rod was used for strength, this isn't your traditional MIG job!

HOME PAGE

Page TWO for COIL OVERS